O-PEN Overview

EV Overview Main Banner

O-PEN® Protected EV Distribution

Olson-EV

Are you installing EV charge points and looking for a compliant alternative to Earth electrodes?

Why do you need to install Earth electrodes?

PME (TNCS) is the most common form of earthing provided at new installations and utilises a single conductor for the neutral and earthing functions (PEN) with an earth terminal derived from the neutral cable. The danger arises if there is an open PEN conductor within the network. This can lead to an electric shock if any metallic parts, including gas pipework and any bonded appliance, were touched by a person in simultaneous contact with the general mass of Earth.

Unfortunately, MCBs and RCDs currently used DO NOT detect this fault and DO NOT offer any protection.

Because of this the IET Wiring Regulations BS:7671 2018 Amendment 1 2020, states that a PME earthing facility shall not be used as means of earthing for the protective conductor contact of a charging point located outdoors or that might reasonably be expected to be used to charge a vehicle located outdoors.

Unless one of the following methods is used

  • The charge point forms part of a three-phase installation where all of the demand including the charge point/s are balanced over all of the available phases
  • The car charging installation includes an Earth electrode of sufficient resistance to ensure the rise of earth potential will be limited to a maximum of 70 V rms during a broken neutral event
  • Protection of electric shock is provided by a device which disconnects the charging point/s from the live conductors of the supply and the protective earth within 5 seconds in the event of a broken neutral

We have the answer……

With the introduction of BS: 7671: 2018 Amendment 1: 2020 it is now very clear what is allowed for protection on EV charge point installations. matt:e has developed a range of connection centres that allow for the compliant connection of EV charge points to PME infrastructures without the use of Earth electrodes.

O-PEN® Distribution boards

PRODUCT FEATURES

  • Available in 4, 6, 8, 12 & 16 triple pole outgoing ways.
  • Choose between 100A or 200A 4 pole isolator incomer.
  • Features a matt:e O-PEN® protection device which monitors the PEN conductor and trips the 5 pole isolators in the event of a fault, automatically reclosing once the fault is cleared.
  • Accepts MCBs from 2A to 63A and RCBOS from 6A to 45A.
  • Dual Earth and Neutral terminal bars.
  • Removable end plates, top and bottom.
  • Removable door.
  • Key hole wall fixings.
  • Additional modular boxes available for RCD’s.
  • Larger sized incomers available upon request.

DID YOU KNOW

The O-PEN® protection device which monitors the PEN conductor and trips the 5 pole isolators in the event of a fault, automatically recloses once the fault is cleared. No need to manually reset the device.

Customise our new O-PEN® Distribution Boards

As a service we can pre populate our NEW O-PEN® boards to suit your installation requirements. Whether that’s providing devices for 3x 7.2kW, 6x 22kW and then blanks to future proof your installation or fully populated with over 24 outgoing ways.

EXTENTION BOXES

We can design purpose-built extension boxes with cut outs to accommodate the hardware on the top or side of your panel and also pre drill the knockouts to aid the installation.

DID YOU KNOW?

As standard we fit the incoming devices in the bottom half of the board, however, if your supply needs to come into the top we can switch this around.

Extension-Box

PRE POPULATED

We can pre fit your board with the required devices either single or three phase to suit the amount of EV chargers that will be used. Saving time when installing on site.